View Full Version : Help, messed up my mold.
Tony2020
10-11-2018, 07:59 PM
So I had been very happy with my lee 230 grain 309 mold. After a few uses I decided to give it a quick scrub with a toothbrush. Well I dont know what I was thinking, the mold was still way too hot and the bristles melted all over the mold, I cant get the gunk off, any ideas or is the mold shot?
Thanks
Tony
redhawk0
10-11-2018, 08:01 PM
Get it reeeeal hot and use a brass brush on it....gently.
You can also try soaking it in acetone...but no promises with this method.
redhawk
Walks
10-11-2018, 08:02 PM
Propane torch and bronze brush ?
tja6435
10-11-2018, 08:18 PM
Rub the plastic out with a popsicle stick
Bazoo
10-11-2018, 08:23 PM
I did the same thing once. Well, I got it out by soaking it in hoppes a few days, and taking a wooden scraper and picking at it. I also used a bronze brush gently, in a side to side motion in the cavity. It worked. Lacquer thinner did nothing, as it will not melt the plastic that the bristles are made out of.
rancher1913
10-11-2018, 08:32 PM
its a lee mold -------- just buy another :lovebooli
LUCKYDAWG13
10-11-2018, 08:42 PM
Try and boil it off ? or maybe freeze it it might just flake off
Rcmaveric
10-11-2018, 09:07 PM
Acetone should dissolve the plastic. Using a popsicle stick and torch sounds good.
Sent from my SM-G950U using Tapatalk
flyingmonkey35
10-11-2018, 09:14 PM
Photos or it didn't happen.
Blow torch just melt it off
Sent from my N9560 using Tapatalk
ShooterAZ
10-11-2018, 09:24 PM
Yep, blowtorch & burn it out. I'd even try "casting" it out first. Personally, I wouldn't scrape on it.
Tony2020
10-11-2018, 09:39 PM
Thanks for the help everyone. A brass brush is already working... slowly. I am going to soak it in solvent again tonight and keep working at it until its clean.
Mxrick55555
10-11-2018, 09:58 PM
I did something similar once... I read somewhere that wax was a good mold lube for the spure plate pivot and lock points so while it was hot I touched a piece of crayon to those areas and immediately regretted it the wax ran into the mold cavities and was a mess think I ended up just casting a bunch until it finally melted/ came out of the cavities. Never again!
Dragonheart
10-12-2018, 07:03 AM
Give it a soak in "Goof Off"
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.