.44 mag NOE 434-310 boolit question

[Blood Trail]

Just reloaded a couple of these with 19 grs of H110. Thought I had mummy OAL correct, but a double check with my calipers revealed an OAL of around 1.600”. The closest load data I have for this boolit has an OAL of 1.710”. Should I pull these out a tenth or are they good to go has they are?

Gun I’m firing is a SBH.


Sent from my iPhone using Tapatalk

[Bookworm]

Do you mean H110?

I just checked my Lyman #4, it shows a Max of 19.3 H110, at a length of 1.710". You are actually over a tenth of an inch short (0.11), not a hundredth (0.010) and you are at 98.4% of max powder load.

If it was me, I would pull those few, dump the load, and start over.

Having said that, the standard for H110 powder is a full case. Are you feeling lucky ?

[Blood Trail]

Do you mean H110?

I just checked my Lyman #4, it shows a Max of 19.3 H110, at a length of 1.710". You are actually over a tenth of an inch short (0.11), not a hundredth (0.010) and you are at 98.4% of max powder load.

If it was me, I would pull those few, dump the load, and start over.

Having said that, the standard for H110 powder is a full case. Are you feeling lucky ?

Thanks for clearing up the typos. [emoji1474]

Not sure what you mean by saying the standard for H110 powder is a full case. I understand H110 don’t like to be reduced. Is this what you’re referring to?


Sent from my iPhone using Tapatalk

[stubert]

I shoot the Lee 310 grain gas check in my Red Hawk at 1.71" with 20.8 Grains of WW296.