brewer12345
10-05-2018, 04:34 PM
I am kind of frustrated dealing with my 35 Rem cast load. I have been working with the classic RCBS 200 grain mold and H4198, since the Lyman cast manual shows good accuracy with this powder. I must gave come up with my load in relatively early spring when it was chilly, because at the range today at 75 degrees it was all over the place rather than an inch or two at 100 yards. Are there less temp sensitive powders I should use instead? Is this just a function of cast loads? I notice that J word loads don't seem to be anywhere near as finicky about temps.