hubel458
08-22-2018, 02:28 PM
Kinda emergency. I need few powder through 1 1/4" powder through expander
dies for 577Snider, made by Lee I have some that have the ID of the bottom
at approx .740" which I need, and have some that are approx .670"
which I don't need. The smaller still works fine for the 577 Snider case, but not
for what I need. ...I will trade new smaller ones plus 20 bucks for
the older bigger ones that measure about .740"
. I don't need other sizing or seating dies in the sets.
They have to be powder through with the 7/8" x 14 thread
in the top for screwing in the powder deal, and 1 1/4
thread on outside for going in the press..Ed
dies for 577Snider, made by Lee I have some that have the ID of the bottom
at approx .740" which I need, and have some that are approx .670"
which I don't need. The smaller still works fine for the 577 Snider case, but not
for what I need. ...I will trade new smaller ones plus 20 bucks for
the older bigger ones that measure about .740"
. I don't need other sizing or seating dies in the sets.
They have to be powder through with the 7/8" x 14 thread
in the top for screwing in the powder deal, and 1 1/4
thread on outside for going in the press..Ed