Has anyone used this mold just wondering how well it has worked for anyone 31-250E

[Nomad666]

Accurate mold 31-250E I was wondering if anyone has tried this mold and if they had any luck with it as I am contemplating getting this mold but am finding very very little info as to its use and no reloading data as of yet and how well or not it shoots it is supposed to drop as .308 from the mold and then be powder coated to size and am just wondering if this is working well or not for anyone that has tried it.

http://www.accuratemolds.com/bullet_detail.php?bullet=31-250E-D.png

[Hamish]

As PC Bullets are a fairly recent movement in the cast community and that these designs were arrived at for subsonic work primarily in the 300 BLK, I seriously doubt you're going to come up with much, if any, published load data.

A caseful of the very slowest powders on the charts or the old 30-06 311284 data, reduced a couple of grains from the start loads would be where I would begin.

[Nomad666]

I thought I would try anyways and see if someone had tried this I will look up the info you gave me just to have a look at it thanks.

[bangerjim]

This is close. Treat NLG's and grooved boolits.

http://castboolits.gunloads.com/showthread.php?131497-Experimenting-with-NOE-247-gr-300-Whisper-boolit-in-a-30-30-Win-94

banger

[475AR]

PM sent.