PDA

View Full Version : 9mm under 900 FPS?



2veeps
07-13-2018, 01:33 PM
The indoor range I belong to requires lead bullets @ 900 fps or less at the 50’ range. Easy enough for my 45acp, but for the life of me, I can’t find a load for my 9mm. Looked at the load data sticky here, but no joy. Figure it would have to be a heavy (145 gr +) bullet to have enough back pressure to eject the brass, but am not sure. Anyone know of a spot that would have my info? PMs with pet loads that meet the criteria accepted. Thanks ahead of time.

-veep

Thumbcocker
07-13-2018, 01:34 PM
Lyman loading manual with 147 grain data.

Grmps
07-13-2018, 01:51 PM
slower - heavier

https://i.imgur.com/YXBoqsW.png?2

John Boy
07-13-2018, 01:55 PM
145 grain Lead RN (Round Nose)
* No. 2 3.7 gr. 893

147 grain FMJ or JHP
* Universal 3.7 gr. 851
No. 2 4.0 gr. 888

tazman
07-13-2018, 01:55 PM
The hodgdon data site shows a few loads for 125grain and heavier using starting loads. Most are with 147grain Bullets

country gent
07-13-2018, 05:28 PM
You might look at the websites for bullseye pistol, there may be some "soft ball" loads for the 9mm they use in matches. But you may need to use a lighter recoil spring in the pistol with these loads.

reddog81
07-13-2018, 08:24 PM
Any starting load with a 140-147 grain bullet should be fine. It depends on the gun but there's a good chance you can go even a bit lower than the starting load and the gun will still function.

2veeps
07-14-2018, 01:26 PM
Thanks to all of you for your input. You folks are great, It is appreciated!
- Veep

Outpost75
07-14-2018, 09:44 PM
I load 147-grain bullets with 3.2 grains of Bullseye, very accurate in SIG P320 and cycle reliably.

GhostHawk
07-14-2018, 10:00 PM
I recently tested my Hipoint C9 pistol with 8 rounds of 125 gr rnfp over 2.5 grains of Red Dot.

You'd have to chrono them but that is half a grain below start.

Pistol ran like a champ, accuracy was ok, mostly out of practice with it.

I actually screwed up and shot them backwards. 8 low cast rounds followed by 5 federal factory loads.

Should have shot the federals first.

Recoil and muzzle blast was significantly less with the light loads. I then came home and loaded up 100 like that, labeled in their own box.

Papercidal
07-15-2018, 04:21 PM
If I recall correctly my 156gr flat point http://castboolits.gunloads.com/showthread.php?346218-Mihec-359-147-no-groove-(Hitek)-for-9mm on top of 3.3gr wsf averaged 814 from a g17 and shot very well and functioned perfectly in multiple glocks from a little 43 to a 34.