Are ballisicast molds convertible to a master caster

[wjham77]

Are ballisicast molds convertible to a master caster

[hunter74]

Yes they are. Change out the sprue plates and the tension on the mould guides. I have used my Ballisti-Cast Moulds in my Bullet Master. It worked ok when the adjustments mentioned abowe, were made. Mine were made by NVM and they are about 3mm narrower than Magma moulds. Because of that the machine have to be adjusted to get the pouring timed right.

With that said, on the BM this is too much work to be done for using a few Ballisti-Cast moulds when my other moulds are Magma moulds. I'm no expert on the MC but this may be simpler to adjust with only one mould used?

Sent fra min SM-G930F via Tapatalk