Echo
05-20-2018, 02:56 PM
A duplicate... can't delete, don't know how, not easily determined in edit mode...
I had a Lyman 4-banger 429244 mold that I had never used, and put it on eBay, sold it - and will get it back in a couple of days. Top of the blocks were chipped, so would not cast suitable boolits. My plan is to take it to a machinist and have him mill the tops of the blocks to take out the GC shank, making them PB boolits. Cost might make it silly to do, but... Any comments?
I had a Lyman 4-banger 429244 mold that I had never used, and put it on eBay, sold it - and will get it back in a couple of days. Top of the blocks were chipped, so would not cast suitable boolits. My plan is to take it to a machinist and have him mill the tops of the blocks to take out the GC shank, making them PB boolits. Cost might make it silly to do, but... Any comments?