View Full Version : Thoughts? Ideas? Stepped away for a bit, and...
8mmFan
05-20-2018, 01:45 PM
That's a pile of formerly Lawrence Brand magnum shot. It was very dusty shot soi decided to melt it down. It got its revenge.
TaylorS
05-20-2018, 02:08 PM
Chip it off and put it back in the pot!
Sent from my iPhone using Tapatalk
MyFlatline
05-20-2018, 02:15 PM
ooops, never leave a pot unattended . Isn't that what starts most kitchen fires? Should be the same for casting. If I have to step away, I shut the pour off and turn down the heat. Got to many things in my shop that I don't want to have to replace..
Kraschenbirn
05-20-2018, 05:16 PM
Uhmmmm…..been there, done that. Cut off the top couple inches of the cone with a pair of bolt cutters (if you've got bolt cutters); that'll give you clearance to pry the rest off the base and slide it out sideways. Chop the big pieces into smaller chunks that'll fit in your pot and remelt.
Bill
Hossfly
05-20-2018, 05:37 PM
It’s a good thing it’s sitting in that old rimmed cookie sheet, good idea. It holds a lot of melt.
AZ Pete
05-20-2018, 05:41 PM
been there, done that.....but only once. I keep an ingot mould under my spout anytime I leave it unattended for a few minutes.
Sent from my iPad using Tapatalk
Bookworm
05-20-2018, 05:42 PM
Years ago, a stray dog showed up, and live on my front porch, in an old end table. Good dog, too. Kept the pocket gophers under control, excellent mouser. Chased off other dogs, guarded the peaches from the squirrels.
When people came over, and asked if the dog would bite, I said "Only if you turn your back on it."
And it would, too.
My Lee pot reminds me of that dog.
jdfoxinc
05-20-2018, 07:53 PM
Nice art.
8mmFan
05-21-2018, 12:33 AM
Hi Everyone,
Thanks for the advice, and the laughs! I will try the bolt cutter technique.
8mmFan
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.