View Full Version : MiHec 502-383
Gunslinger1911
05-05-2018, 03:08 PM
Finally got to play with the big 3 cav 500 !
With my alloy, had to run pot 25-50 deg hotter - mould happy with pot about 775 deg.
HP's about 380g, solid about 390.
Little ole 45-200 hp on left; 50-325 j word on right for perspective
Don Purcell
05-06-2018, 08:44 PM
Gunslinger, I take it this is the recent group buy? If so, my solid also came out at 390 grs. but haven't tried the hollow points yet.
Gunslinger1911
05-07-2018, 09:42 AM
Hi Don, Yes recent group buy. These look great for my 50ae, 50 Beo, 500 Smith.
Haha, kept getting wrinkles, thought I wasn't getting it clean, as said above, a little more heat and no worries !
I have each of the pins in the mould - how convenient, 3 cavity's, 3 diff nose pins !
Don Purcell
05-07-2018, 01:38 PM
I just put in the flat nose but will try what you did and try them all at one time. Would like to get the 3.5 inch S&W .500 for these and the JR Alley Cleaner.
Hi Don, Yes recent group buy. These look great for my 50ae, 50 Beo, 500 Smith.
Haha, kept getting wrinkles, thought I wasn't getting it clean, as said above, a little more heat and no worries !
I have each of the pins in the mould - how convenient, 3 cavity's, 3 diff nose pins !
Is there any load data for these that would work in the 50AE? I thought it might be a bit long.
Gunslinger1911
05-07-2018, 09:20 PM
Echd, don't know about the AE, about all I ever found was data for 325-350g. I'll have to look for the old data I used for my 50ae Blackhawk - maybe more forgiving than an Eagle ?
Boolet is 0.787" oal. 0.405" base to crimp groove. If that helps ?
Rattlesnake Charlie
05-07-2018, 09:42 PM
Looks like it should take a care of any tyrannosaurs that happens your way.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.