View Full Version : Hornady Bullet feeder die part 2
Well, the 38/357 Bullet feeder dies are garbage. Very frustrating, no amount of adjusting helps. That being said, the 45 ACP feeder die works perfectly. Go figure
Papercidal
03-20-2018, 09:28 AM
I have had the same experience with them the mr bullet feeder die has been great despite the price.
Livin_cincy
03-22-2018, 07:03 PM
I have the 380/9mm die. I think it was a return at Cabbalas. I did not work out of the box.
I opened up the fingers/collet that hold the bullet. I pushed a bladed screw driver into each gap. Very gently to pry them open. Then when you put it back in the die it will size to your bullet.
I think if you set the die up wrong it will compress the gap and it happens over time from use.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.