View Full Version : mold handles
shotman
09-04-2008, 01:37 AM
does anyone know if the Lyman 4 cavity handles will fit the 4 cavity H&G mold ? shotman
shotman
09-04-2008, 03:30 PM
anyone know? i know rcbs and lyman are some what different rick
C1PNR
09-04-2008, 03:56 PM
Well, I thought this would be an easy one to answer. Turns out my "storage" of moulds and handles is so disorganized right now that I can't tell which is the H&G handles, the new Lyman handles, or the SAECO handles.
I guess you'll just have to try what you have on what you want to fit.
I'm still hoping Red River Rick will come up with a solution to our 4 C problems with some of his Superb custom work. I just hope his health allows him to continue.:drinks:
shotman
09-04-2008, 11:40 PM
well i have the H&G blocks but dont have any 4 cav in anything else guess i will buy a Lyman and try it shotman/rick
Bob Krack
09-05-2008, 01:10 AM
well i have the H&G blocks but dont have any 4 cav in anything else guess i will buy a Lyman and try it shotman/rick
Rick,
Can ya give a set of measurements so we can try to help supply other info?
I've seen Lee 6-cavity handles fit many other brand of moulds.
The dimensions needed are:
Slot width,
Slot depth,
Bolt diameter (the bolt that holds the handles to the mould)
Width of mould - inside the slot. That is the center unslotted portion.
Distance from back of mould to bolt center.
With Lee 6-cav handles being well under $20 shipped, I would certainly investigate that possibility.
Vic
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.