View Full Version : Holster for my Taurus.
Handloader109
03-09-2018, 10:06 PM
I've always enjoyed leatherworking, not really done much in past few years until recently. Decided to work with my laser on cutting out the leather, cutting the holes for the sewing and on this one, engraving. My first four were for my two 1911s, and my ppq. Finally got holes right so I don't have to clean out residue or repunch. Used an all in one stain finish, so far it held up well on my ppq which has been daily carry for about 4 months.
https://uploads.tapatalk-cdn.com/20180310/205be5095037dcb63bd2862d9c888c27.jpgbefore stain
https://uploads.tapatalk-cdn.com/20180310/0a524df707f25a143ce6273a52ef6f01.jpgstained
https://uploads.tapatalk-cdn.com/20180310/2d25f1c7413b88238966549c5aa2374e.jpg
The good side
Sent from my SM-G892A using Tapatalk
MaryB
03-09-2018, 11:27 PM
I never had a lot of success cutting leather with my laser when I had it. What wattage machine and power level did you use?
Bazoo
03-09-2018, 11:33 PM
Very nice. Could you elaborate on the finish you used please.
CastingFool
03-09-2018, 11:45 PM
Nice job! I like the stitching, very even.
Rcmaveric
03-10-2018, 01:10 AM
Nice work. Looks like mighty fine work. I was just looking at new holsters.
Bzcraig
03-10-2018, 01:14 AM
Looks great on my screen.
Mr_Sheesh
03-10-2018, 04:59 AM
I'm curious about laser power as well. Have a 30W IR Engraver / cutter, need to upgrade the laser some day.
Handloader109
03-10-2018, 10:11 AM
I'm curious about laser power as well. Have a 30W IR Engraver / cutter, need to upgrade the laser some day.I've a great big Chinese machine. 80watt, 35 x54 inch bed. I use about 40 percent to cut at 12mm/sec travel. About 6 min to cut holes and outline. A 30 watt machine is way sufficient for most stuff.
Sent from my SM-G892A using Tapatalk
Mr_Sheesh
03-10-2018, 02:30 PM
Nice! So many uses for those (Only down side is the fumes from cutting some things aren't exactly nicely scented :P) I imagine leather's nicer than plastics at least.
Handloader109
03-12-2018, 09:56 AM
Nope, plastics, wood, everything smells better than leather........ But my extractor fan is pretty good.
Sent from my KFAUWI using Tapatalk
nagantguy
03-12-2018, 11:11 AM
Very well done, take pride in your work because that's a fine looking holster! Thanks for the write up, I also dabble in leather work and have a neighbor with a laser cutter he makes signs and such never even thought about its application on leather.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.