View Full Version : 311467 OAL for 30/40 Krag
Does anybody have the correct overall length with this bullet in 30/40 Krag? I have a bunch of these I want to plink with. Not going to load them very hot, probably starting load. Given this mold design with so many grooves, I would think pressure would be low.
rmcc
Bent Ramrod
02-01-2018, 08:37 AM
The measurement I get is 3.140” overall. I usually single load, but IIRC they do feed through the magazine. Lots of grease grooves showing, so don’t drop them on the ground. :mrgreen:
Thanks a ton!! That was what I was looking for!! Yes, they do have a lot of grooves!!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.