PDA

View Full Version : Anyone used a 311466 boolit in the 300 Blackout?



AZ-JIM
12-05-2017, 09:13 PM
208954

It looks funny to me, but the seated depth is where it meets the rifling. It feeds great from the magazine. These are gas checked and obviously powdercoated, they weigh 160 grains.
What powders have you used, sub or super loads?

az-jim

oldblinddog
12-05-2017, 10:18 PM
I use it in the .308 Win. I'm sure you will like it!
208962
This load is about 1345 fps. 1-10" twist 20" barrel.

AZ-JIM
12-05-2017, 11:18 PM
Nice group, I would be thrilled if mine shot like that

popper
12-06-2017, 10:46 PM
1680 should work. Problem is seating depth. See how much powder will fit in case, check sub loads to insure load is safe. If an AR I'd back off the bore a bit. Don't know if it will cycle ok. Or find a different mould.

oldblinddog
12-06-2017, 10:52 PM
I'd think that you could get a nose sizing die from NOE so that you could seat the bullet further out, assuming the magazine will accomodate it.

jimb16
12-09-2017, 09:42 PM
I use that bullet in my .30-30 single shot. Best bullet I've found so far.

Motor
12-12-2017, 04:38 AM
I'm surprised they only weigh 160gr. I use the 160gr 2R TL powder coated. Mine weigh between 166 and 168 grains depending on if they are gas checked or not. I haven't tried them super sonic yet from the BO only non cycling sub-sonic.

Here are some with gas checks. I don't have any photos with them loaded in the BO yet but can post a OAL if needed.

Motor

JDL
12-12-2017, 12:09 PM
Motor, I don't believe those a 311466 bullets in your photo.

jimb16
12-13-2017, 09:11 PM
They aren't. The 466 is a Loverin design.

oldblinddog
12-13-2017, 10:11 PM
He said:

I use the 160gr 2R TL powder coated.

I think he knows they aren't 311466's and is suggesting a different bullet. But I've been wrong before.

AZ-JIM
12-17-2017, 09:32 PM
I decided to go for it and loaded up a few. The group pictured was with 7.0g of Blue Dot. They did not cycle my carbine gas system which I figured would be the case. They are slow and pretty quiet. It made me laugh a little to hear the gun go off, then hear it smack the target at 50 yards and then hit the berm. I think I will load them again but probably try to get them to cycle next time.209739

Motor
12-18-2017, 04:49 AM
He said:


I think he knows they aren't 311466's and is suggesting a different bullet. But I've been wrong before.

Yes they are Lee 160gr 2R TL. No I'm not suggesting he use a different boolit, I was simply posting my experience. I'm using 4.5gr Bullseye in my subs. My accuracy is at least as good as what's posted in the photo. :)

Motor