Wanted: Lyman 401452 mold.

[gilgsn]

Thanks!
Gil.

[maxreloader]

This is a great mold for the .401 wsl. There are two different version molds one had a flat-base and the other a bevel-base. They come up from time to time on the E site. Single cavity are most common, the dual cavities are extremely hard to find. Hope this helps!

[gilgsn]

This is a great mold for the .401 wsl. There are two different version molds one had a flat-base and the other a bevel-base. They come up from time to time on the E site. Single cavity are most common, the dual cavities are extremely hard to find. Hope this helps!Thanks, I have a saved search on that site, if one pops up I'll get an email... Now, if someone here has one picking up dust somewhere, I'll put it to good use!
Gil

Sent from my SM-G928F using Tapatalk

[bruce drake]

https://www.midsouthshooterssupply.com/item/0000690470/double-cavity-mold-401-145-swc
Check this mold out if you have a long wait time from Lyman.
My 400 Corbon 1911 loves this LEE 145gr SWC. It comes out at close to 148gr with my standard alloy and after sizing/lubing. It didn't care at all for LEE's bigger 170gr Truncated Cone bullet but their light bullet is the bee's knees.

[gilgsn]

https://www.midsouthshooterssupply.com/item/0000690470/double-cavity-mold-401-145-swc
Check this mold out if you have a long wait time from Lyman.
My 400 Corbon 1911 loves this LEE 145gr SWC. It comes out at close to 148gr with my standard alloy and after sizing/lubing. It didn't care at all for LEE's bigger 170gr Truncated Cone bullet but their light bullet is the bee's knees.Thanks Bruce. What size does it drop out of the mold?

Gil

Sent from my SM-G928F using Tapatalk

[bruce drake]

I use a Lee .401 push through sizer and it sizes up nicely. I'll pull an unlubed as-cast out of the box tonight to give you a reading for pre-sizing.

[gilgsn]

Thanks, much appreciated.

Sent from my SM-G928F using Tapatalk

[bruce drake]

unlubed straight out of the mold with the following lead alloy run: 50lbs of Magnum Lead shot/5lbs of Roto Metals Super Hard Alloy/5lbs of 60/40 Solder (14 Brinnell)

Measured 5 bullets pulled at random:
.4015"
weight: 145.6gr

Hope this helps.

[gilgsn]

unlubed straight out of the mold with the following lead alloy run: 50lbs of Magnum Lead shot/5lbs of Roto Metals Super Hard Alloy/5lbs of 60/40 Solder (14 Brinnell)

Measured 5 bullets pulled at random:
.4015"
weight: 145.6gr

Hope this helps.Great, thank you!

Sent from my SM-G928F using Tapatalk