View Full Version : I need a favor
GOPHER SLAYER
11-25-2017, 09:42 PM
If you own a Little Dandy powder measure I could use your help. My friend made me two rotors for mine and he did a great job but now I need to drill them for the powder chamber. What I need is the size of the powder chamber for #s 11 and 16, both the width and depth. Thanks
rockshooter
11-25-2017, 10:11 PM
pretty close will be:
#11= 0.315 diameter, 0.425 deep
#16= 0.585 diameter, 0.425 deep
Loren
rockshooter
11-25-2017, 10:17 PM
oops!
#11= 0.315 diameter, 0.545 deep
Loren
Minerat
11-25-2017, 10:48 PM
I checked mine just to verify.
#11=0.311 dia x 0.544 deep
#16 = 0.450 dia x 0.426 deep (triple checked)
I use RCBS metal dial calipers not pin gauges for the diameter.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.