Crash_Corrigan
10-26-2017, 04:05 AM
I finally got around to try to load some virgin Starline cases in 327 Fed. The sizing die stops squeezing down the casing just before the rim.
After the case is loaded it will not fit into the case gauge. It goes in just to the bulging part where the full length sizing die failed to reach.
What can I do to get it to fully size the casing?
After the case is loaded it will not fit into the case gauge. It goes in just to the bulging part where the full length sizing die failed to reach.
What can I do to get it to fully size the casing?