Lee 2-Cavity Bullet Mold TL356-124-TC For 380 auto

[forrest-hunter]

I have been using this mold for my 9mm - has anyone used it for 380? If yes - any suggested load using unique - just bought a bersa thunder

[gwpercle]

Not a lot of feed back on this one....wish I could help but my mould is the 356-120-TC , not the tumble lube version. With this boolit I find 2.7 grains of Unique is pretty good , but not my favorite.
For the 380 I like to use a little faster powder like Bullseye, Red Dot , 700X or 231 .

At one time I used Unique for everything , even 32 acp...but these small rounds don't develop enough pressure to completely and cleanly burn Unique so you might get a few unburned powder flakes . No big deal but some folks get all upset about it and holler...Unique burns dirty !
Gary

[forrest-hunter]

I have been using unique for all my pistol loads 380,9mm,38,357,45acp,45colt and 44mag - have not had any problems other then burns dirty - have 4# so really don' want to swith

[CraigOK]

http://castboolits.gunloads.com/showthread.php?98571-380acp-125-gr-LRN

Seems like case capacity might work against you. Give that link a read, it might help