View Full Version : Short brass
pull the trigger
06-03-2017, 11:38 PM
I have some 30-30 brass that has been blown out to 38-55. It measures right at 2" with is .085" short. Its too short to reach the crimp in my rcbs dies. Would a lee factory crimp die reach it? Thanks
fred2892
06-04-2017, 04:17 AM
Possibly may reach, but get the Lee die anyway. They are easily modified by removing metal from the bottom of the sliding sleeve, in this case, remove .085" and it will fit your needs. I have done this to a few Lee factory crimp dies for use with cartridges they were never designed for. I've also added metal to accommodate cartridges longer than the original die intended.
Sent from my Galaxy Tab 2 using Tapatalk
pull the trigger
06-04-2017, 07:30 AM
I ve never tried one before. Guess I will!! Thanks
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.