Took on a weird cartridge....Need a Lubrisizer die they don't make!

[fatelvis]

I bought a cheap, unfired Ruger #1 in 9.3 X74R chambering. I'm buying NOE's 286grn mold, but for the life of me can't find a sizer die for my RCBS lubrisizer in .368" diameter. I don't think Lyman or RCBS make them in that size. Can anybody steer me in the right direction as to who carries or makes them? Thanks guys...

[Yodogsandman]

Sign up for the next run of these here...

https://www.buffaloarms.com/368-custom-bullet-sizing-die-for-lyman-rcbs-lubrisizers-bac368

[bessemer20]

I believe that lathesmith in the vendor section would also make you one.

[Bzcraig]

Buckshot might make them too......

[Beagle333]

Sadly...... Buckshot has retired and doesn't make dies or HP molds anymore.

[JeffG]

I believe that lathesmith in the vendor section would also make you one.

This. Check with Lathesmith. He made a custom one for me, for 9mm Mak.

[Cherokee]

I recommend Lathesmith.

[fatelvis]

Lathesmith is on it. Thanks for the suggestion guys!


Sent from my iPhone using Tapatalk

[fatelvis]

I just got my die from Lathesmith. Simply beautiful, It looks as if it rolled off of RCBS's production line! Thanks Lathesmith!

[Oklahoma Rebel]

I am fixing to get a 9.3X62 in another month or so,hopefully, I am definetly smitten with the CZ550 FS (Full length Stock) so let me know how your loads go, I am planning on using h4895, starting at about 48grs with a 250 and a 285 gr RNFP GC accurate mold combo but these cartridges are slightly different, I'd have to look, but I think the 62 is a higher pressure cart. than the 74, though both will do the same thing.