View Full Version : load using IMR4198 in k31
mto7464
07-20-2008, 09:54 AM
anyone have any good load for their k31 using this powder? I have a variety of boolits from 165-200 grain.
Maven
07-20-2008, 03:41 PM
Start at 18grs. and work up to 22grs. of IMR 4198.
Ditto Maven's suggestions.....I'd be surprised if 18.5 grs didn't shoot well.
beemer
07-20-2008, 07:41 PM
Seems we all agree, I was going to suggest about 20 gr. Thats where I start in most of my full size milsurps.
beemer
runfiverun
07-20-2008, 11:42 PM
that seems to be an universal load recommendation for cases about that size.
if you have the rcbs silhouette boolit that pours about 300 on the nose and bout 310 on the body, it is hard to go wrong with that combo.
don't be scared of a bit of dacron in there either
beemer
07-21-2008, 05:54 PM
I use a little dacron too, about a half to 7 tenths of a grain depending on the case. Seems to be more accurate when the powder stays in one place.
beemer
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.