AnotherNew1
05-23-2017, 09:13 PM
I believe this is a good choice: https://www.mp-molds.com/e-shop/molds/alternative-coating-molds/mp-359-125-hp-pb-4-cav-no-lube-groove
I can't seem to find a lot of info on this creature, however i believe it would perform well? Due to reading a lot about His other HP Molds with Lube.
So any and all advice or experience would be welcome. Books I've been reading and threads i could find do not seem to imitate this design. They all seem to have 2 of 3 design aspects.
With Hi Tek and powder coating options i believe the lack of lube rings help shorten bullet and therefore imitate XTP HP 124G performance more closely (Case Pressure & Velocities from OCL?)
I'm thinking FPS? Hardness? Goals. Also any Tips or tricks with HP Brass Molds.
In Case you are wondering: 4" barrels or less
Thank you:
I can't seem to find a lot of info on this creature, however i believe it would perform well? Due to reading a lot about His other HP Molds with Lube.
So any and all advice or experience would be welcome. Books I've been reading and threads i could find do not seem to imitate this design. They all seem to have 2 of 3 design aspects.
With Hi Tek and powder coating options i believe the lack of lube rings help shorten bullet and therefore imitate XTP HP 124G performance more closely (Case Pressure & Velocities from OCL?)
I'm thinking FPS? Hardness? Goals. Also any Tips or tricks with HP Brass Molds.
In Case you are wondering: 4" barrels or less
Thank you: