View Full Version : Forming 6x47 rem brass?
andym79
04-28-2017, 05:15 PM
Hi guys I am looking to make a rimmed version of the 6x47 rem. Do you think it could be done from 5.6x50r?
Yes but you will have to trim the longer brass after forming.
joatmon
04-29-2017, 02:34 AM
That round sounds neat, is it your brainchild.
Aaron
andym79
04-29-2017, 02:51 AM
Don't know if its been done before but I want one in a single shot so its better if its rimmed.
skeettx
04-29-2017, 10:59 AM
http://www.bellmtcs.com/FAQ/about_the_5%206%20cartridges.htm
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.