AbitNutz
04-27-2017, 05:16 PM
So I love my Lyman case prep station. It makes processing brass cases almost a pleasure compared to doing them by hand.
It has one glitch. The outside case neck deburring tool will drive you mad if you are doing larger mouth cases...like 45's. It is almost impossible to get the case centered on the spinning tool the first or even third time for me. At which point it just tries to grab the case from your hand. Many times I have given up.
Now steps in RCBS. They make an outside chamfer deburring tool that works spectacularly well. It's a carbide affair and is like a carbide funnel. I was worried it wouldn't screw into the Lyman but it does.
If you have a problem doing large mouth cases and have the Lyman case prep station...the RCBS chamfer tool will fix things right up.
http://rcbs.com/Products/Case-Preparation/Case-Trimming/Trim-Mate-Carbide-Chamfer-Tool.aspx
It has one glitch. The outside case neck deburring tool will drive you mad if you are doing larger mouth cases...like 45's. It is almost impossible to get the case centered on the spinning tool the first or even third time for me. At which point it just tries to grab the case from your hand. Many times I have given up.
Now steps in RCBS. They make an outside chamfer deburring tool that works spectacularly well. It's a carbide affair and is like a carbide funnel. I was worried it wouldn't screw into the Lyman but it does.
If you have a problem doing large mouth cases and have the Lyman case prep station...the RCBS chamfer tool will fix things right up.
http://rcbs.com/Products/Case-Preparation/Case-Trimming/Trim-Mate-Carbide-Chamfer-Tool.aspx