johnson1942
04-20-2017, 05:25 PM
sent my cylinder to DOUG GUY and he made all the exit holes the same size and so they would pass a 451 bullet through them with ease. also tapered the cartridge side a tiny bit so the fired shell fall out with ease. i redid the forcing cone my self as i have the cutter and pilot (11 degree). got the cylinder back to day and leaning up against a big old round bale and shooting at a piece of old tin barn siding i kept all 6 in one hole the hole was the size of a quarter with no fliers. before i sent the cylinder the DOUG GUY the group was the size of an old silver dollar with one cylinder shooting 2 inches low. if you want your revolver to shoot boring tight groups have DOUG GUY do a cylinder and forcing cone job on it. he doesnt break the bank either. thanks DOUG.