454PB
03-13-2017, 11:27 PM
I dropped a piece out of my RCBS hand priming tool (model 90200) at my loading bench. It rolled away, never to be found again, and believe me, I spent over an hour on my knees with a flashlight trying to locate it.
I can make a new part fairly easily, as I own a lathe, but I need measurements to do this. I realize that RCBS can supply one, but if I had measurements, I can make one in 20 minutes. I need length, OD, and ID.
The part is called a "link follower", and is actually a small piece of pipe that fits over the spring and seating punch within the priming tool. The part number is 7-90215 for any of you that have this tool and the instructions manual.
Any help would be appreciated.
I can make a new part fairly easily, as I own a lathe, but I need measurements to do this. I realize that RCBS can supply one, but if I had measurements, I can make one in 20 minutes. I need length, OD, and ID.
The part is called a "link follower", and is actually a small piece of pipe that fits over the spring and seating punch within the priming tool. The part number is 7-90215 for any of you that have this tool and the instructions manual.
Any help would be appreciated.