PDA

View Full Version : Encore Forend screws


cabezaverde
02-07-2017, 08:43 PM
Does anyone know the length and size of the screws needed for an Encore rifle forend?
cabezaverde
02-10-2017, 05:17 PM
No One?
NSB
02-10-2017, 06:21 PM
check Numrich or simply call TC.
bdicki
02-10-2017, 06:32 PM
http://www.bellmtcs.com/store/index.php?cid=592
cabezaverde
02-10-2017, 06:44 PM
Thanks guys,

I was just hoping to pick some up locally.
dave22250
02-10-2017, 07:04 PM
The threads are 8x40 lengths I'm not sure I have aftermarket forends...
BCRider
02-11-2017, 03:35 PM
With the fore end sitting in place run a toothpick down and bottom out in the hole. Mark the toothpick, withdraw and measure. Buy slightly long and dress to final length with a file.

If you have wood stocks then each one will vary slightly based on how much the screws were tightened down previously. TC elected to not use bushings in the fore stocks so the wood crushes down a little more each time the stock is mounted or until the screw bottoms out.