LeroyvdH
01-09-2017, 01:02 PM
I have a 50cal RB mould bought new a couple years ago. Just got around to using it. Had just used my stash of Hornady RB's up..
The problem - The screw that holds the handle to the block stripped out after 20 pours.. I know adout the warrenty but by the time and cost to shipp it from Canada I might as well buy a Lyman and call'er good and gone..
Due to my Dutch heritage... I was thinking of drilling out the holes and using a roll pin to repair the mould.. Any thoughts?
Thanks Leroy
The problem - The screw that holds the handle to the block stripped out after 20 pours.. I know adout the warrenty but by the time and cost to shipp it from Canada I might as well buy a Lyman and call'er good and gone..
Due to my Dutch heritage... I was thinking of drilling out the holes and using a roll pin to repair the mould.. Any thoughts?
Thanks Leroy