encore rifle forend

[jason f]

just picked up an encore barrel chambered in 476 gnr. the barrel i had on it was a 22-250. the two screw holes line up but channel is to small on forend. which forend do i need to buy to make this work. thanks jason

[dave22250]

Is it a factory heavy or a full bull barrel??? Dave A muzzleloader forend might work....

[jason f]

Looks pretty close to a full bull. Not much taper at all. I will have to measure muzzle to see.

[jason f]

after the chamber swell the barrel looks the same diameter all the way to the muzzle. the chamber swell to the barrel isnt much of a diameter difference at all.

[jason f]

just measured it with micrometer. after chamber swell barrel is .940 and the muzzle end is .840

[dave22250]

Same measurement I'm getting from my muzzle loader barrel, hole spacing looks the same.