Ruger Lockup

[joatmon]

Took the grandson shooting today and had my new to me 32H&R SS lockup during loading! The cylinder charge holes are so sharp they were shaving brass and then a round got stuck a little shy of seating all the way. Think I'll round the edges slightly to stop the shaving if I can get it apart!
Aaron

[44man]

It won't hurt. Were they reloads? Dies can make a difference if they were.
I have a habit of neck sizing a lot of revolver loads but eventually they all need FL. But I have seen dies that would never take brass to fit.
I have been to the point I needed to tap a dowel on the edge of a case, sure need to stay away from the primer. After a hard thumb push I will FL.