David R
10-27-2005, 06:22 AM
OK, I tried it, I have a 7.65 arg that has a bore of .314. I took a 311359? Pointed 30 cal boolit mold made for an M1 carbine. It was throwing out of round boolits from .309 to .313. I Took it to work, and did the leement thing to it. I drilled 2 boolits, screwed in a deck screw and cut the head off. Chucked em in the drill press, put valve grinding compound on it and closed the mold for 60 seconds. Repeat....Repeat..... Then I got lazy and just crammed the drill bit into the boolit until it grabbed it. Put on some valve grinding compound and away I went. After I had a pile of 10 abrasive impregnated boolits, I quit and cleaned the mold real well. Took it home and poured a few. Absolutly no improvment. SO if you see a 311359 on Ebay, don't buy it, cause it drops out of round boolits.
I have to try our group buy C314-1502R to see if it shoots. It goes through the .314 push through sizer I bought form LEE with some resistance.
David
I have to try our group buy C314-1502R to see if it shoots. It goes through the .314 push through sizer I bought form LEE with some resistance.
David