View Full Version : can i use .230 bullets in a .228 barrel
1899-510
06-13-2016, 08:34 PM
newby to reloading and was having a hard time finding ammo for 1899 savage hi power22. i came across a load of .230 bullets in the correct dimensions i have been looking for. the ammo i have has bullets from .220 to .226 old stock, reloads,norma, s and b so obviously size is not an issue or is it? save me from myself
fixed it some for ya.
M-Tecs
06-13-2016, 08:36 PM
Do you mean .230"?
1899-510
06-13-2016, 09:00 PM
of course. thats my public education showing
GhostHawk
06-13-2016, 09:04 PM
No.
Go try to put a .308 bullet (standard USA .30 caliber) down a .22 caliber barrel. They won't fit, they won't go in the brass and if they did they would not go in the chamber.
Start by reading the sticky on slugging a barrel or chamber cast. Then go do that. Measure carefully, twice.
Buy bullets or molds 1 to 2 thousands over. 0. tenths, hundredths, thousands.
Once you know what your barrels groove diameter is you can size bullets or molds 1 to 2 thousandths bigger and it should work.
It would be like trying to shoot a .43 caliber aka .44 mag in a .357. It is nay going to fit laddy.
1899-510
06-13-2016, 09:07 PM
i'm sorry barrel is .228 boolits are .230
skeettx
06-13-2016, 10:21 PM
Hello
and
WELCOME on your first postings here :)
Cast, yes, start at the low end of pressure and work up
Loads are listed in Lyman Manual #45 Page 285
Mike
Wolfer
06-13-2016, 10:25 PM
Is this cast or jacketed? If cast they will be fine if they will chamber.
If jacketed and if they chamber I would start low and work up cautiously.
.002 is not much of a squeeze.
runfiverun
06-14-2016, 12:04 PM
yes.
.230 cast boolits would actually be a preferred diameter in your .228 barrel.
your fine.
Shiloh
06-14-2016, 07:41 PM
.230 will work. What are they as cast?? I run .312 in my military relic .30 cals.
Shiloh
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.