View Full Version : Offf the wall question
lcclower
05-27-2016, 12:07 AM
Is anyone making H&G style sprue plates to fit other molds? Thicker and grooved I think is better.
168994
JSnover
05-27-2016, 12:10 AM
I don't know if anyone sells them as aftermarket parts but it's not uncommon to modify them that way.
Outpost75
05-27-2016, 12:11 AM
When ordering a new Accurate mold you can specify.
lcclower
05-27-2016, 06:25 AM
"When ordering a new Accurate mold you can specify."
TYVM I didn't know that.
ascast
06-05-2016, 10:09 AM
i think someone here does them for Lee 6 bangers as well
jcren
06-05-2016, 10:12 AM
Yep, that would be red river Rick.
country gent
06-05-2016, 12:22 PM
I make my own sprue plates with 1/4" thick starret o-1 gage stock I perfer the thicker plates and bigger sprue chamfers I get this way. I also vent or cut a trough to the edge of the blocks and between cavities. This allows "over pouring" when I ladle cast. The bigger sprue chamber keeps the base hot longer also. I have also found this thicker spru plate dosnt tnd to float or warp as much.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.