Crosshair
05-12-2008, 11:10 PM
I am pulling my hair out over my Lee TL314-90-SWC mold. I keeps dropping boolits at ~.316" instead of .314. They won't fit in my Ruger 32 H&R without sizing to .312" and then the lube grooves are almost non-existent.
I'm thinking that I should just size the whole batch, tumble lube them again and just see how well they shoot. I'm kinda pissed about having to lube them a second time since the reason I bought this mold is so I wouldn't have to perform the messy job of lubing twice, but I'll get over it.
Anyone else had trouble with this boolit? I'm thinking about getting the Lyman 311252 for my 32 H&R needs if the Lee doesn't shoot good when I try it.
/Just need to vent.
I'm thinking that I should just size the whole batch, tumble lube them again and just see how well they shoot. I'm kinda pissed about having to lube them a second time since the reason I bought this mold is so I wouldn't have to perform the messy job of lubing twice, but I'll get over it.
Anyone else had trouble with this boolit? I'm thinking about getting the Lyman 311252 for my 32 H&R needs if the Lee doesn't shoot good when I try it.
/Just need to vent.