Was Fortunate

[6pt-sika]

I was lucky yesterday !

I won a auction on Ebay yesterday for a Lyman 257325 two cavity mould !

Cost me $65 so I think I did alright ! Think I will turn my single cavity 257325 into a HP version !

Now I will have plenty moulds for my Marlin 1893 in 25-36 Marlin !

Anybody run across a two cavity 321297 I would be intrested !

That would work nicely with nicely with the 32 Special and I could take my single cavity 321297 and make a HP out of it also !

[6pt-sika]

Think I could also use a nice two cavity Lyman 257312 also and make my single into a HP version !

[9.3X62AL]

Sika--

I also have a one-cylinder #257312. Tell ya what--it takes a while to fill a 1# coffee can with castings from THAT mould. Of course, the 2-holers in #257420 and RCBS 25-85-CM don't exactly overflow the can in 10 minutes, either.

[6pt-sika]

Sika--

I also have a one-cylinder #257312. Tell ya what--it takes a while to fill a 1# coffee can with castings from THAT mould. Of course, the 2-holers in #257420 and RCBS 25-85-CM don't exactly overflow the can in 10 minutes, either.


I have a double cavity 257420 and I can relate ! However it's a nice bullet when I take my time !

I also have a little two cavity 225415 for my 218 Bee ! Now that one also takes awhile to get dropping correctly !

[Bret4207]

Glad one of the brothers got that mould. I got side tracked and forgot about it. Sure wish they'd bring back some of those designs.