Lee Precision C501-440-Rf where does the lube go

[havfun]

501 diameter 440 grain
this is for the SW 500
getting a star sizer die made for this bullet

[44man]

Lower groove and the one above the check. if you crimp in the top groove you can also use the lower crimp groove for lube. Not usually needed though. Just does not hurt anything.
The two at the top are crimp grooves and depends on cylinder length as to what you use. Load work must be done with your choice of course.

[runfiverun]

44 man has it, at least that's what I would do.

[havfun]

thanks will do

[acoop101]

Skip it and powdercoat.... For the price of one star sizing die you can set up for shake and bake powdercoating.

[gwpercle]

I do chicken and pork chops with Shake and Bake....not bad !