View Full Version : Anybody know what these are?
str8wal
04-03-2016, 11:52 AM
I was going through some reloading stuff of the grandfather of a cousin of one of my son's in law who passed recently and found these. There are 3 segments bound with a rubber band. Anybody?
165277
salpal48
04-03-2016, 11:55 AM
Yes, They are the insert for The hammer type Bullet puller. Could be any manufacturer
seagiant
04-03-2016, 12:08 PM
Yes, They are the insert for The hammer type Bullet puller. Could be any manufacturer
Hi,
Probably, RCBS!
lcclower
04-03-2016, 12:10 PM
RCBS, Franklin, I think they all come from the same factory. Just use shell holders, that works better.
LUBEDUDE
04-03-2016, 04:13 PM
A few years back I ordered some of those from Dillon for my Dillon impact hammer and they sent me ones still in the RCBS sealed package.
seagiant
04-03-2016, 04:26 PM
A few years back I ordered some of those from Dillon for my Dillon impact hammer and they sent me ones still in the RCBS sealed package.
Hi,
Yep!
bangerjim
04-03-2016, 05:06 PM
Inserts for an inertia puller as said. For which manufaturer? Who knows.
I would not loose any sleep worrying about selling those.
banger
str8wal
04-04-2016, 10:30 AM
I would not loose any sleep worrying about selling those.
Ha ha. Well they will probably in the S&S in a few days along with some other things. I have been placed in charge of dispersement since I am the only one in the "family" who is into this kind of stuff. Thanks for the education, all.
brass2bullets
04-09-2016, 10:28 AM
Impact bullet puller hammer inserts. They hold the brass end allowing the bullet to come out.
Sent from my iPhone using Tapatalk
Those are the first things I discard from an impact bullet puller,the holders for the ram are much better and the inserts for a hand primer work good also.
rondog
04-09-2016, 02:52 PM
Huh, never tried using shellholders....I'll have to try that!
Hardcast416taylor
04-09-2016, 03:01 PM
I use shellholders from my Rockchucker in my impact hammer when I need to pull some loads apart. It must be just me, I have the open side of the shellholder facing back towards the handle. This makes for less case rattle. I also put an E.A.R. ear plug in the bottom of the hammers cavity to save deforming bullet tips.Robert
BigMagShooter
04-10-2016, 08:05 PM
bullet puller parts
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.