holsterguy
03-26-2016, 11:37 AM
Hi, sure this has been asked like a gazillion times,but trying to decide between a few different molds for 9mm.
I have a hi power clone. Near as I can tell the barrel is .356. The rifling seems to start right at the end of the chamber with no leade.
Trying to decide between a few different Lee molds IF they will drop a bullet large enough to be sized or just shot at .357
Choices- 356-125-2r, tl356-124-2r, or 356- truncated cone. (Not tl one)
Anybody have any luck with either? What size do they drop? Will be using coww with a little tin added.
Thanks.
I have a hi power clone. Near as I can tell the barrel is .356. The rifling seems to start right at the end of the chamber with no leade.
Trying to decide between a few different Lee molds IF they will drop a bullet large enough to be sized or just shot at .357
Choices- 356-125-2r, tl356-124-2r, or 356- truncated cone. (Not tl one)
Anybody have any luck with either? What size do they drop? Will be using coww with a little tin added.
Thanks.