PDA

View Full Version : Needed a Lyman or RCBS 6mm top punch


brstevns
03-02-2016, 11:21 AM
Looking for a RCBS 509 or Lyman 203 bullet nose punch.
brstevns
03-23-2016, 10:01 AM
anyone?
Ole Joe Clarke
03-23-2016, 02:36 PM
If you have a lathe, I have a drawing. The drawing is for a flat tipped nose punch blank.
brstevns
03-23-2016, 04:37 PM
If you have a lathe, I have a drawing. The drawing is for a flat tipped nose punch blank.
No lathe, I wish I had one.
s mac
03-23-2016, 04:53 PM
I take a piece of .25 automotive steel tubing, Brake line tubing, available at the auto parts store, cut a short piece fill the flare with JB weld and place in your lubesizer on a greased boolit nose to cure.
brstevns
03-23-2016, 08:00 PM
I take a piece of .25 automotive steel tubing, Brake line tubing, available at the auto parts store, cut a short piece fill the flare with JB weld and place in your lubesizer on a greased boolit nose to cure. Good idea thanks.