Thompsoncustom
02-27-2016, 11:40 AM
I've been reading my manual for quickload lately trying to figure out how to add a powder to the program.
Firstly I'm trying to add Winchester AutoComp and Quickload is asking for Minimum and Maximum BA values and that's not something I have and I'm not sure how to look up the BA values of other powders so I can get it close.
I would image if I could get a starting point than I would be able to test loads(chrono) and correct the data in quickload to match. Any Quickload experts point me in the right direction?
Firstly I'm trying to add Winchester AutoComp and Quickload is asking for Minimum and Maximum BA values and that's not something I have and I'm not sure how to look up the BA values of other powders so I can get it close.
I would image if I could get a starting point than I would be able to test loads(chrono) and correct the data in quickload to match. Any Quickload experts point me in the right direction?