Just added some more to my list.

[vrh]

To cold to be outside, so I went to the garage. Poly coated some 30-06 bullets and loaded them up.
Cast 100 bullets up to be coated later as needed.
Applied gas check and sized in my Lee sizer. I tumbled these in a # 5 container with 1 layer of steel BB's and HF powder. Swirled and shook the container for approx: 30 seconds. Transfered to baking rack and baked for 20 minutes at 400 degrees. Resized again and loaded them up.
158765

[dahermit]

I tumbled these in a # 5 container with 1 layer of steel BB's and HF powder.
Harbor Fright Blue?

[vrh]

Sorry about that. ( At my age I can blame it ) The red ones are HF. The blue ones are RAL powder.

[popper]

Looks like you need a better seater nose plug.

[vrh]

Nope.....That would cost money. Does me just fine.

[glockky]

Some hot glue or epoxy in the seating stem will fix the problem cheaply

[vrh]

Took apart the seating die. The seating die stem was in backwards. Everything is hunky dory now.

[Mark454]

My casull dies had a funky seating stem so I just removed it and ground off the edges of the cone. All of my bullets are flat nose so it worked perfectly

[Dragonheart]

If you are casting in the garage I sure hope you have some good ventilation for the lead pot?