Needed a couple of pieces of 7/8x14 with a pilot hole

[brstevns]

In need of a couple of pieces of 7/8 x 14 with a pilot hole all the way thru of maybe 3/64 inch, Pieces only need to be 2 1/3 to 3 inch long.

[SOFMatchstaff]

3/64's (.046) ?? that's mighty small for a 3" long hole, you sure of the diameter ?

[brstevns]

3/64's (.046) ?? that's mighty small for a 3" long hole, you sure of the diameter ? Could get by with a 3/32" Also 2" pieces would work.

[fg-machine]

care to give us an idea of what you are doing ?

7/8-14 screams die's ... if so , bolts and all thread are a poor choice along with mild steel .

depending on your needs , if you wanted to pay the freight i can thread a couple pieces of 01 and drill the pilot hole as deep as the drills i have on hand allow (1.5")

[brstevns]

care to give us an idea of what you are doing ?

7/8-14 screams die's ... if so , bolts and all thread are a poor choice along with mild steel .

depending on your needs , if you wanted to pay the freight i can thread a couple pieces of 01 and drill the pilot hole as deep as the drills i have on hand allow (1.5") PM sent

[brstevns]

My cousin and I are going to make a couple of point dies or should say going to try to make.

[Nueces]

My cousin and I are going to make a couple of point dies or should say going to try to make.

In that case, you could consider counter drillling a larger size from the top and making your ejector pin of two diameters, for strength. Your small bore hole need be only the length of a bullet plus, say, a quarter inch.

You dies makers chime in here, see if I make sense.

[chuckbuster]

Just stumbled on this, if you still need something let me know via PM
Kevin

[fg-machine]

on its way



157462

[BrassMagnet]

on its way



157462

Sweet!

[brstevns]

Sweet! You said it! Nice Really Nice. Thanks again fg-machine :-)

[brstevns]

fg-machine They arrived today, beautiful, just beautiful. Can't wait to continue the project.

[fg-machine]

so bill ,... is this what it should look like :-)

159197

[brstevns]

so bill ,... is this what it should look like :-)

159197Yes Sir that would be it. Looks Great.