lar45
12-29-2015, 07:45 AM
Hi all.
I've been playing with slug loads in my Norinco 87 12ga and find myself wishing for better sights.
The receiver does not have much room to play with and the top of it is dished in, so mounting a rear sight base might be abit awkward.
I've been searching Brownells and found a shorty front ramp.
http://www.brownells.com/userdocs/skus/l_962011125_1.jpg
I'm not really sure on how to go for the rear sight.
Something like this would be great if I could find one to match up with the reciever or barrel contour.
http://www.brownells.com/userdocs/products/l_962100037_1.jpg
Also I read somewhere that epoxying the bases down was a reasonable alternative to sliver soldering?
I would appreciate any suggestions.
Thanks
Glenn.
I've been playing with slug loads in my Norinco 87 12ga and find myself wishing for better sights.
The receiver does not have much room to play with and the top of it is dished in, so mounting a rear sight base might be abit awkward.
I've been searching Brownells and found a shorty front ramp.
http://www.brownells.com/userdocs/skus/l_962011125_1.jpg
I'm not really sure on how to go for the rear sight.
Something like this would be great if I could find one to match up with the reciever or barrel contour.
http://www.brownells.com/userdocs/products/l_962100037_1.jpg
Also I read somewhere that epoxying the bases down was a reasonable alternative to sliver soldering?
I would appreciate any suggestions.
Thanks
Glenn.