View Full Version : lubing bullets without putting lube on shank
canuck4570
12-16-2015, 10:34 PM
155804
I took a .309 pin and hand it machine to accept the shank of a bullet that use a gas check
works great
155805
155806
scattershot
12-16-2015, 10:35 PM
Great idea, thanks!
35 shooter
12-16-2015, 10:45 PM
That is a neat solution! I would have never thought of that.
canuck4570
12-16-2015, 10:49 PM
and I use the same pin even if I size with a .310 .311 .312 sizing die
no lube escape just have to use the correct pressure on the lube sizer
james nicholson
12-18-2015, 02:47 PM
I think I am missing something. Why not put the check on before lubing?
MT Chambers
12-18-2015, 04:59 PM
As a fellow Kanuck I am a bit perplexed myself, my Star or Lyman will install the gc and lube completely, including the small groove left just above the gc, all in one go. If you are not concerned about accuracy and just want to run those without a gc, just tumble lube them. If I don't want to use GCs I will use a PB mold.
canuck4570
12-18-2015, 05:10 PM
the point of the machined pin is to lube any gas check bullet and not putting the lube where usually it goes and also not having pub in the chamber
then I able to use these bullet for plinking
tumble lube attract dirt and everything stick to them not for me
and not has many choice it plain base mood
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.