Reccomend a top punch for my mold?

[zubrato]

My mold is an Accurate http://www.accuratemolds.com/bullet_detail.php?bullet=32-205B-D.png
with a .18" meplat, and I wish it was smaller. When I end up using the supplied flat top punch sometimes the meplat ends up widening, and in some cases lightly catches on the chamber and shaves off a bit of lead. Not a big deal, and still VERY accurate but it bothers me looking in the chamber and seeing little lead flakes.

I think a good bandaid would be using a spitzer style boolit top punch that fits in a .325 sizer, and maybe help round those edges or swage them pointier.
All help appreciated if you guys could point me in the right direction.

Thanks!

[randyrat]

Use a hollow top punch then fill the hollow with JB weld and push your oil coated bullet in and you will have a custom top punch for your bullet. Make sense, I'm only on my first sip of coffee

[gwpercle]

J-B Weld Epoxy Putty is a little easier to work with than their regular epoxy glue, it doesn't run.
Knead a small ball and use it to custom fit the boolit perfectly.
Gary

[Boogieman]

Any RN top punch that will enter the sizing die should round the edges. Adjust your bullet stop to keep the rounding even. I do this to make RNFP s out of RN s

[JonB_in_Glencoe]

NOE offers top punches for all his molds.
this one looks about identical, nosewise
http://noebulletmolds.com/NV/product_info.php?cPath=30&products_id=296