Mypin PID settings question

[10x]

I have a Mypin PID that reads the correct temperature, turns the SSR on, but does not auto tune. The post simply keeps heating until temps are much higher than the target temperature - (ie. set for 670 F the pot will simply keep heating until 800F or more.)

Any one have some suggested values for " P ", " I ", and " D " settings

I have used the REX C100 with no problems - the Mypin is beginning to be a little challenging.

[Mike W1]

PM sent to you.

[JonB_in_Glencoe]

I don't have a mypin, but here are the parameters for my PID (JLD612).
I have no idea if the algorithms in the software are similar enough for the parameters to be compatible ?


P=1.0
I=111
d=27
Souf=0.2
ot=2
FiLt=0

[Mike W1]

Here's a couple.
.93 84 21
7.79 93.50 23.37