Quick Load data wanted for 35 Remington

[jfd444]

I was hoping that someone with QuickLoad could provide some data for me. It would be for a 35 Remington with an 18.5" bbl with:
a. 180 gr .360 dia cast bullet 0.755" long with a cartridge OAL of 2.230"
b. 200 gr .359 dia cast bullet 0.890" long with a cartridge OAL of 2.455"
Max pressure 38,000 PSI and max load density of 105%.
Case capacity is 51.4 grs of H2O
My powders on hand are Bulleseye, Red Dot, Trail Boss HP-38, Unique, Blue Dot, A2400, Lil Gun, RL-7,I3031, I4064, Tac, BL-C2, RL-17 and H4831(reg and SC).
Thanks, any help would be greatly appreciated.

[Beerd]

not Quick Load and not cast but from Hodgdon
..

[RU shooter]

Not quick loads either but I shoot the 35 in that same barrel length had real good luck with practice loads using 12-14 gr of 2400 with 180-200 gr cast . As for full speed loads use the RE7 up through the blc-2 powders u listed and just start at the min loads listed for jacketed bullets and work your way up till accuracy falls off . I use a max load of either H335 or A2230 listed in my speer manual with very good accuracy with cast .

[357Mag]

JFD -

Howdy !

Let's not forget.... typical case capacity measurement using H20; fills case w/ water to-the-case-mouth.
Dependent on your boolit and seated depth, your case' neck might be completely occupied w/ " boolit ".

In those instances, your .35 Rem case's " Effective case capacity " ( measured w/ H20 ) will be notably lower-than 51.4gr.


With regards,
357Mag