243winxb
10-10-2015, 04:49 PM
Would this apply to my Lyman 4 cavity handles?
Hipshot: Lay the head end of the pivot pin (which i really a big rivet) on an anvil, and whack the other end (look for a circular "parting line" where it goes into the rounded "washer" on the back side) a couple of times with a medium ball-peen hammer. If it gets too tight, lay it, head down, on a stack of large washers, or across the open jaws of a vise, and whack the riveted end back out a bit with a matching punch. May take a coupla tries, but should do the job. 1 is the Head End? Thank you for your help. http://i338.photobucket.com/albums/n420/joe1944usa/2015%20Reloading/1Lyman_zpsvmxuyubo.jpg http://i338.photobucket.com/albums/n420/joe1944usa/2015%20Reloading/2Lyman_zpsw99nmb1l.jpg
Hipshot: Lay the head end of the pivot pin (which i really a big rivet) on an anvil, and whack the other end (look for a circular "parting line" where it goes into the rounded "washer" on the back side) a couple of times with a medium ball-peen hammer. If it gets too tight, lay it, head down, on a stack of large washers, or across the open jaws of a vise, and whack the riveted end back out a bit with a matching punch. May take a coupla tries, but should do the job. 1 is the Head End? Thank you for your help. http://i338.photobucket.com/albums/n420/joe1944usa/2015%20Reloading/1Lyman_zpsvmxuyubo.jpg http://i338.photobucket.com/albums/n420/joe1944usa/2015%20Reloading/2Lyman_zpsw99nmb1l.jpg