Back Tang Screw ORIGINAL 1886

[TCLouis]

1/4X?? or more slightly oddball?

Source (someone that actually has one)

How about hammer for this gun??

[fouronesix]

The specs for the main stock screw for an 86 are: length 1 25/32, diameter 11/32, thread 12-28.

There were 3 basic types/models of hammers- primarily differing in the type of checkering.

Been so long since I've looked for such parts- not much help about a source.

[oldred]

1/4X?? or more slightly oddball?

Source (someone that actually has one)

How about hammer for this gun??

I needed to check something on Ebay so while there I looked for that hammer and screw, both are available but the one hammer I could find was kind of spendy -$325!! :shock:


http://www.ebay.com/itm/Winchester-Model-1886-Hammer-Trigger-2-/150965414410?hash=item23263d6a0a


Maybe they do go for that but personally I think someone rolled one out of the wrong bag! The search for the hammer also brought up a couple of those screws, one for ten bucks.

[John Taylor]

You can get a new screw from Wisner's http://www.wisnersinc.com/part-catelog/

[Ballistics in Scotland]

Here is a source for what I think is the screw you want. They also do a set of all external screws.

http://homesteadparts.com/shopcart/pid_821.htm

I bought a kit for the 1886 long ago from Brownells, though they no longer stock it. It may have been by the same manufacturer. There is a lot of rebadging in the gun accessories business.